For ceiling mounting PVC film required her operational heating to a temperature of about 65 degrees.The best thing with this task can handle gas gun for suspended ceilings, which effectively warms the air in the room.
power source device - the liquefied gas.The price of the equipment is quite high.
What is the gas gun
Every specialist knows that the ceilings without heat gun can not be mounted.After all, it is necessary to heat the fabric.
point is the following features:
- Fabrics PVC film made smaller in comparison with the area of the ceiling where they are installed;
- PVC film is stretched only at 65 degrees and above, and it will pull together during the cooling back to its original size;
- in hot (extended) state edge PVC films are attached to the preassembled baguettes and fixed;
- After the film has cooled down, the ceiling will restore the previous size, thereby forming a smooth and level surface.
should be noted for reference: in the measurements may be error in no
Without proper experience with their hands such work is not recommended, even if you have watched a lot of photos and video.
examining mounting technology using a PVC film (cm. PVC Stretch ceilings - the technology of the installation), you need to learn gun device for suspended ceilings.Virtually all models of the same type.
- gas cylinder;
- connecting hose for gas;
Specialists greatest interest is the design of the gun, which determines the level of heating the web and ensure safe operation.This can explain the fact that every element of the heat gun made of steel, which is resistant to high temperature.
gas Heat gun for suspended ceilings - is, by and large, hollow steel cylinder. steel sheet covered with powder enamel, which can withstand prolonged heating.
addition, the inside of the cylinder are:
- gas burner;
- supply valve that controls the flow of gas;
- Piezo (flammable device);
- Guards at the back and front.They protect the gun from getting a gun obstructions.
Tip!The manufacturer's instructions states that in the process of working with the gun it is necessary to ensure full air circulation on both sides.The fact is that the air mass while passing through the gun nozzle not only heat the PVC film, but the structure is cooled and the heat gun.
feed (connection) hose and gas, in most cases, have to buy separately.Using a heat gun for suspended ceilings, it is necessary to observe all safety rules, focusing on proper fueling gun.
job with a gun begins with the fact that opens the shut-off valve that blocks the gas supply, then a specialist:
- With built-igniting device ignites the gas;
- warms the gas burner;
- , increases gas supply;
- Starts electric fan;
- An air stream for PVC film.
It should be noted that the recent cases of careless handling with gas heat gun, which lead to accidents.
Therefore, many experts liked electric heat gun for ceilings:
- electric gun on the design similar to the gas gun within the cylinder instead of the gas burner is a heating element.
- These guns were made before, but his power and speed of the heating could not compete with gas guns.
- Despite this, in small spaces electric gun for suspended ceilings can provide their normal capacity warm fabric stretched ceiling.
Security Council!Gas heat gun for suspended ceilings, or rather her gas tank should be refilled at special stations.Where the balloon would not only be completed correctly (80-85% of the total), but it will be drained condensate and test the functionality of the locking elements.
most dangerous consequences are in violation of the rules of use of the gas cylinder, since natural gas is stored under pressure there 15-16 atmospheres. If charging is done correctly, this leads to the fact that during heating cylinder room gas will expand rapidly, often resulting in an explosion.