- Preparation of materials and tools
- Plastering Interior Plastering corners
- outer corners
Technique plastering interior and exterior angles of space has its own characteristics and requires careful preparationthe adjoining wall surfaces.Main attention is paid to the quality of a corner joint in compliance with all regulations stipulated parameters.
nowadays practiced two ways to align the joints in the corners of the walls, the use of which is determined by the views of the subsequent finishing of the walls of the room.In the case when the walls of the room is supposed to hang wallpaper with the selection of the figure - angle can be aligned on the level.When they plan to finish with the help of plaster, it is usually resorted to the equalization of plane.
Preparation of materials and tools
Before plastering the walls of the corners you will need to prepare appropriate materials through which you will be able to align the corner areas by app
encourage you to buy only high-quality ready-mix, manufactured by reliable and proven manufacturers.This is considered the best option plaster, prepared on the basis of plaster (it is called the starting filler).
To organize plastering you need to prepare the following items and tools:
- plastic bucket;
- electric beater, whisk;
- rule and a set of spatulas;
- special "grout";
- set different grits of sandpaper.
Plastering of the interior angles
Align inner corner beacons
To align the corners of this kind of monitoring beacons are installed directly in the corner.For a smooth and unobtrusive "tightening" is made out of the angle should be used generally for the possibility of a larger size (length).
pre-treatment is to remove the corners (knocking) it stands out from the mounds and ridges, allowing you to save on the amount applied putty.After leveling the surface of the soil composition of deep penetration, which further strengthens the treated area and improves the adhesion of the layer of putty.Priming is performed on the entire width of the rules used in the preparation of the corner, or even a little more.
Application corner spatula
After drying the soil can be caused to move to the preparation corner of the lighthouse, which is executed in the form of five-centimeter strips of plaster.For its preparation used gypsum mixture, which is primarily to avoid the formation of lumps thoroughly mixed.
The finished mixture is applied to the corner portions, and then aligned in a vertical plane by the rule.After leveling the mixture, and it is completely dry it will be necessary to prepare another lighthouse, which must be located on an adjacent wall.
plaster interior angles
After the beacons are prepared, you can go to a "tightening" of the walls near the corner joint, produced by the same rules.When applying plaster onto the wall over the entire length rule one of its ends has to rely on previously established beacon, while the other is carried along with the wall while cutting off excess material.Blocked with the right layer of putty can not be reused because the dried fragments disturb the plasticity of the solution and uniformity of the final mass.To eliminate ("hammering") visually distinct grooves or scratches can apply another layer of the solution and make a "pulling" angular surfaces by means of the same rules.
Plastering of outer corners
Plaster corner outer corner
before plastering wall corners on the outside you have to knock down all the build-up with her and projections.Only then you can proceed to priming the surface is prepared for plastering.For high-quality plastering the outer corners it is recommended to use special profiles, which are perforated metal slats certain length, running in a corner.
Being essentially ready lighthouses, such profiles are fixed at the corners by pressing them into the already deposited on the surface of the walls of the solution.Then you can remove the excess plaster mixture and check the verticality of the structure in both planes.
offer to see the following video of the plaster of the interior angles: