- Features fence of metal sheets
- Preparing the base frame
- Installation of sheet metal profile
use of metal profiles for the production of modern fences due to the presence ofthis wonderful building material following characteristics:
- reliability and durability,
- attractive appearance,
- increased strength,
- wide range of colors.
high strength characteristics of protections of metal sheets allow them to withstand extreme wind loads and provide improved The security burglar.
Given the previously discussed advantages of the increased interest to the user, how to make the fence of metal sheets is entirely justified.This circumstance explains the need to review this matter all stakeholders.
Features fence of metal sheets
gate of metal sheets
Manufacturing technology involves the use of metal sheets of steel billets size, which is obtained after stamping sheet given shape.After that, the surface of the workpiece a first layer of corrosion protection is a
for everything fence profile on the basis of the sheet metal stock you will need the following tools and materials:
- iron pipe diameter of 60 mm;
- metal profile is used for the production of beams;
- steel corner, from which the welded frames gate and wicket.
gates and metal sheets
With regard to the need for a tool for the construction of the fence before us the type you need:
- cutting tool ("Bulgarian»),
- shovel (to dig holes undersupport),
- tamping arbitrary design,
- building level,
- measuring tools,
In addition, you may need auxiliary tools, including a set of screwdrivers and a set of saw blades.
Preparing the base frame
Installation metalloprofilnogo fence circuit
Basic operations for the manufacture of the fence is typically produced in a certain sequence, the main stages of which are as follows:
- Firstto mark the land on which you are going to install a fence of metal sheets.To this point of the angle columns marked a pole from it will continue to measure out the lengths to indicate pillar sites (towers).
- distance between adjacent pillars should be maintained at intervals equal to approximately 1.1 meters;And in the immediate vicinity of the gate, these distances will need to be reduced to half.The gap between the supports embedded gate should be at least 4 meters.
- It goes without saying that before the erection of a fence from metal sheets with their hands should be all the necessary earthworks, including the preparation of pits for pole-support.Note that the working depth of the pits at the height of the support of 2.5 meters must be at least 0.7 meters.After installing the base of the column in the prepared for him deepening the lower part of the support it is covered with the previously extracted land, which is then thoroughly compacted.
- followed in pre-marked area to the posts welded pieces of metal profile used as beams.When installing the latest special attention should be paid to control parallel lines mounted profile that best manages to track through the construction level.
Installation of sheet metal profile
Features fence installation scheme
Upon completion of all these operations, you can begin to install the sheets of metal sheets, which are attached directly to the mounted skeleton consisting of columns and beams.During the installation of specialized pieces, special attention should be paid to the preservation of decorative polymer coating, damage which is unacceptable.
Installation metalloprofilnogo fence
alignment lines of the upper and lower edge of protections can be implemented by cutting all the irregularities produced before the installation of blanks in place.Before starting this operation, you will need to make a preliminary layout prepared for the installation of sheets.
step instructions for installation of the fence can be seen below: