- Plastering ceiling
- Plastered ceiling
- Steps for
when repairing the apartment or office, all major work often after doing afinishing the ceiling.The main objective of this process - the level the surface.It is both the most difficult part of the work.Alignment is necessary in any case, regardless of the coating method ceiling whether wallpaper, paint or drywall (in this case need to seal the seams).
to preparatory work took place efficiently and successfully, it is important to pick up all the necessary tools and observe the sequence of instructions given by experienced professionals.This will require:
- metal spatulas, preferably multiple types and sizes;
- a mixing solution with high and straight sides;
- brush or roller to apply the primer mixture;
- skins for final polishing of the surface of the ceiling.
Remove old wallpaper
Preparations begin with the fact that the ceiling is completely cleaned of
next step is priming.But before that it is important to determine in what way will be the alignment of the ceiling with his hands, as it affects the choice of the primer mixture.There are several types of it:
- for water-based paints,
- plaster and putty,
- universal primer.
This method is used for finish leveling ceilings at very strongly curved surfaces.In this manner, it can be aligned as concrete and steel and wooden ceilings.It is thanks to its functionality this method is the most popular.A layer of plaster should not exceed 5 cm, so the establishment of special beacons, respectively, may be no more than the allowable size.After the leveling plaster work, irregularities or spray after drying can be cut or sanded special float construction.Then apply the finishing coating layer which is closely aligned.
makes an ideal smooth surface
If irregularities do not exceed 5 cm, then it is possible to use dry plaster mixture.They are best used in small areas to carry out local work, for example, plugging cracks and dents, as this material is quite expensive.
Processing drywall seams serpyanka
perfectly flat surface can be created using putty.This effect is achieved due to the fact that it is applied in a thin layer and its structure is smaller than that of plaster.Before applying the filler surface is thoroughly cleaned and skin.After that, the adhesive attaches a special paint grid.Today there are many types of networks, including the acquisition has a self-adhesive material.
After the surface is completely ready to use putty, you can mix the solution.To this end it is diluted with water and thoroughly stirred with a mixer or a drill of the construction with a special nozzle.
When the solution is ready to be quickly, but carefully, put it on the prepared surface of the ceiling, as it pretty soon begins to thicken.To do this, use a wide spatula, which is dialed by a small portion of the mixture.Tightly clutching a large spatula to the ceiling, apply layer of putty.If the plane at the same time remain divorces, no worries and spend time on their alignment, as after drying sandpaper to sand the ceiling, and all the little bumps are completely eliminated.If all used building material from one manufacturer will significantly improve both technical and aesthetic performance of the work.
So the finish is applied putty:
Since applying putty is the main final stage of leveling the ceiling, it is important to follow all manufacturer's instructions and specialists.To summarize, the work is divided into several stages:
- preparation - cleaning of the ceiling,
- coating primer deep penetrating blend for better grip materials,
- fixing masking grid,
- first starting putty layer no thicker than 1 cm,
- and topcoatresurfacing after drying ceiling.
important to remember that before further staining the plane should once again ready to process the surface of the primer.
putty joints plasterboard ceiling
cracked plaster close up
throwing by a mixture