- Preparing for installation
- design elements of the roof assembly
Steel Pipe profile belongs to the category of the most attractive materials used in the regeneration of a diversity of designs.The particular attraction of profile pieces associated with the presence of the set of remarkable properties, the main ones being the ease of preparation of pipes, ease of molding and assembly.
This explains the high demand for specialized products among private traders, plans to assemble the frame of the house with their hands shaped tube.
At the initial stage of assembly work, you should determine the optimal parameters of profile pieces (their section and the total number), providing robustness and reliability of the future framework.You must then designate those areas of construction, for the construction of which will be used pipe metal profiles.It should be noted that the profile of the metal tube can be collected:
- base binding and sex;
- frame exterior walls;
- interior walls;
- base floor and roof.
Preparing for installation
mount frame house
for independent preparation of the carcass structure of the profile, you can use standard sets coming into free sale.In this case, its installation is reduced to simple assembly operations, produced by classical screw connections.
In case you decide to use for mounting the individual profiled blanks - you will have to recruit a specialist in welding and prepare complete set of the equipment.In this composite metal structure assembly is made, typically in situ construction of the future structure.
When installing the frame structure is necessary to strictly comply with all instructions for assembly, paying particular attention to the quality of the welding of separate components.
Since the mass of metal prefabricated low - as a foundation base can be used in conventional concrete blocks and piles of small size.
carcass of the shaped tube is usually made in the following order:
- primarily prepared waistrail whose elements are welded securely to the foundation bookmarks (pins).This mount gives the erected structure necessary stability and rigidity.Then
- elements sill corner posts welded frame.
- intermediate vertical supports are mounted on the perimeter of the structure, equidistant from one another (equal to or slightly less than the width of the cladding material).
- You can then go to the final consolidation of racks by welding it to the top trim.In order to impart additional stability design is recommended to use special spacer made of the same profiles and welded to the strapping elements.
To build the frame members experiencing high load impact (waistrail and racks) are commonly used pipes with wall thickness of 8 mm and a cross section of 100x100 mm.Additional spacers are made of the profile section 60x60 mm.
Special care should be taken to the profile logs on that plank subfloor and which are fixed on the sill beams by welding.
When it is finished you can go to the installation of intermediate floor.This frame structure includes a set of special profiles fixed on the walls erected structures and beams, to which is attached below the ceiling paneling.
assembly elements of the roof
Farms of shaped tube
At the final stage of preparation of the frame of the house with their hands shaped tube going truss system structure, which may be part of the entire structure, or be a separate structure.
In case you use to close the roof of lightweight materials (polycarbonate, ondulin slate or transparent) - assembly of lightweight structural elements is most easily done on the ground.Prepared in this way the farm can then climb up and weld them to the strapping elements.For the preparation of the roof of the heavy materials will need to use more powerful profiles.The assembly structure in this case is best carried out directly on the roof.
as the main bearing element of the roof - mauerlat - uses a powerful channel to which subsequently all the other elements are fixed roof (purlins, rafters, ridge support, etc.).